Description
Switch – Throttle – Rev/2 – Right-Hand
- Required for installation of Revolver Throttle Kit on bikes with ignition and starter switches in stock throttle assembly
- Fits 7/8″ bars (22.2 mm)
- Extra-narrow design is only 26 mm wide
- Push In/Out engine switch
- Momentary 2-pole starter switch
- Starter switch has two separate circuits, one normally open, one normally closed for street bikes that use a headlight/starter cutoff
- 550 mm long wiring harness with brake light switch circuit wiring
- Brake light circuit wiring pigtail 120 mm long with female spade connectors
- Stainless steel screws and internal rubber pad positions switch on handlebar securely without drilling holes
- Wiring harness has bare, tinned wires without connector for easy installation of OE connector body
- Made in Italy by Domino
Reviews
There are no reviews yet.